[Subject Prev][Subject Next][Thread Prev][Thread Next][Subject Index][Thread Index]

[linux-users:40091] モニタの解像度


橋爪と申します

 実は私もX windowの解像度がうまく設定できないのです。
 ”[linux-users:39995] Gateway EV700 monitor”とその一連のレスポンスで同様の問題が扱われていたので興味深く見ていたのですが、結局水平周波数をモニターの性能に合った値に調整し直すというのが解決策になったようで、私の場合とはやや異なるようです。

 私の場合も1024x768以上の解像度を実現できないのが問題で、XF86Setupでモニターの周波数は規定値以内に納めて入力しています。

 XF86Setupで、モニターの周波数を直接H:30-64,V:50-160と入力して解像度で1024x768を選んでみたりしたのですが、こちらも同じで砂嵐が縦に流れていくような画面になります。


モニター:IBMのAptiva770に付属の15インチモニター
 (モニター全面に貼ってるシールにはこう書いてある)
0.28mm DotPitch FST-SVGA
Multi-Scanning/Non-Interlaced
1280*1024 Max Resolution
 (モニターのガイドにはこう書いてある)
水平周波数:30KHz-64KHz
垂直周波数:50Hz-160Hz

----------------------
SuperProbeの結果:

First video: Super-VGA
	Chipset: Trident GUI 9680 (PCI Probed)
	Memory:  1024 Kbytes
	RAMDAC:  Trident Built-In 15/16/24-bit DAC
		 (with 6-bit wide lookup tables (or in 6-bit mode))
----------------------
X -probeonlyの結果


XFree86 Version 3.3.3 / X Window System
(protocol Version 11, revision 0, vendor release 6300)
Release Date: November 16 1998
	If the server is older than 6-12 months, or if your card is newer
	than the above date, look for a newer version before reporting
	problems.  (see http://www.XFree86.Org/FAQ)
Operating System: Linux 2.0.35 i686 [ELF] 
Configured drivers:
  SVGA: server for SVGA graphics adaptors (Patchlevel 0):
      NV1, STG2000, RIVA128, RIVATNT, ET4000, ET4000W32, ET4000W32i,
      ET4000W32i_rev_b, ET4000W32i_rev_c, ET4000W32p, ET4000W32p_rev_a,
      ET4000W32p_rev_b, ET4000W32p_rev_c, ET4000W32p_rev_d, ET6000, ET6100,
      et3000, pvga1, wd90c00, wd90c10, wd90c30, wd90c24, wd90c31, wd90c33,
      gvga, ati, sis86c201, sis86c202, sis86c205, sis86c215, sis86c225,
      sis5597, sis5598, sis6326, tvga8200lx, tvga8800cs, tvga8900b,
      tvga8900c, tvga8900cl, tvga8900d, tvga9000, tvga9000i, tvga9100b,
      tvga9200cxr, tgui9400cxi, tgui9420, tgui9420dgi, tgui9430dgi,
      tgui9440agi, cyber9320, tgui9660, tgui9680, tgui9682, tgui9685,
      cyber9382, cyber9385, cyber9388, cyber9397, cyber9520, 3dimage975,
      3dimage985, clgd5420, clgd5422, clgd5424, clgd5426, clgd5428,
      clgd5429, clgd5430, clgd5434, clgd5436, clgd5446, clgd5480, clgd5462,
      clgd5464, clgd5465, clgd6205, clgd6215, clgd6225, clgd6235, clgd7541,
      clgd7542, clgd7543, clgd7548, clgd7555, clgd7556, ncr77c22, ncr77c22e,
      cpq_avga, mga2064w, mga1064sg, mga2164w, mga2164w AGP, mgag200,
      mgag100, oti067, oti077, oti087, oti037c, al2101, ali2228, ali2301,
      ali2302, ali2308, ali2401, cl6410, cl6412, cl6420, cl6440, video7,
      ark1000vl, ark1000pv, ark2000pv, ark2000mt, mx, realtek, s3_virge,
      AP6422, AT24, AT3D, s3_svga, NM2070, NM2090, NM2093, NM2097, NM2160,
      NM2200, ct65520, ct65525, ct65530, ct65535, ct65540, ct65545, ct65546,
      ct65548, ct65550, ct65554, ct65555, ct68554, ct69000, ct64200,
      ct64300, mediagx, V1000, V2x00, p9100, spc8110, generic
(using VT number 7)

XF86Config: /etc/XF86Config
(**) stands for supplied, (--) stands for probed/default values
(**) XKB: keycodes: "xfree86"
(**) XKB: types: "default"
(**) XKB: compat: "default"
(**) XKB: symbols: "us(pc101)"
(**) XKB: geometry: "pc"
(**) XKB: rules: "xfree86"
(**) XKB: model: "jp106"
(**) XKB: layout: "jp"
(**) Mouse: type: PS/2, device: /dev/mouse, resolution: 100
(**) Mouse: buttons: 3, 3 button emulation (timeout: 75ms)
(**) SVGA: Graphics device ID: "Primary Card"
(**) SVGA: Monitor ID: "Primary Monitor"
(**) FontPath set to "/usr/X11R6/lib/X11/fonts/misc:unscaled,/usr/X11R6/lib/X11/fonts/75dpi:unscaled,/usr/X11R6/lib/X11/fonts/100dpi:unscaled,/usr/X11R6/lib/X11/fonts/Type1,/usr/X11R6/lib/X11/fonts/Speedo,/usr/X11R6/lib/X11/fonts/misc,/usr/X11R6/lib/X11/fonts/75dpi,/usr/X11R6/lib/X11/fonts/100dpi"
(--) SVGA: PCI: Trident TGUI 96xx rev 211, Memory @ 0x40000000
(--) Trident chipset version: 0xd3 (TGUI96xx)
(--) SVGA: BIOS reports Clock Control Bits 0x0
(--) SVGA: Detected a Trident 9680.
(--) SVGA: Revision 1.
(--) SVGA: Using Trident programmable clocks
(--) SVGA: chipset:  tgui9680
(--) SVGA: videoram: 1024k
(**) SVGA: Using 8 bpp, Depth 8, Color weight: 666
(--) SVGA: Maximum allowed dot-clock: 135.000 MHz
(**) SVGA: Mode "800x600": mode clock =  69.650
(--) SVGA: Virtual resolution set to 800x600
(--) SVGA: Generic SpeedUps selected (Flags=0x30)
(--) SVGA: Using Linear Frame Buffer at 0x040000000, Size 1MB
(--) SVGA: Using Graphics Engine.
(--) SVGA: Using 1024 byte display width.

----------------------
XF86Config

(略)

Section "Monitor"
   Identifier      "Primary Monitor"
   VendorName      "Unknown"
   ModelName       "Unknown"
   HorizSync       31.5-48.5
   VertRefresh     55-90
   Modeline  "800x600"    50.00 800 856 976 1040 600 637 643 666 +hsync +vsync
EndSection

Section "Device"
   Identifier      "Primary Card"
   VendorName      "Unknown"
   BoardName       "Trident TGUI9680 (generic)"
   VideoRam        1024


EndSection

Section "Screen"
   Driver          "Accel"
   Device          "Primary Card"
   Monitor         "Primary Monitor"
   DefaultColorDepth 8
   BlankTime       0
   SuspendTime     0
   OffTime         0
   SubSection "Display"
      Depth        8
      Modes        "800x600"
   EndSubSection
   SubSection "Display"
      Depth        15
      Modes        "800x600"
   EndSubSection
   SubSection "Display"
      Depth        16
      Modes        "800x600"
   EndSubSection
   SubSection "Display"
      Depth        24
      Modes        "800x600"
   EndSubSection
   SubSection "Display"
      Depth        32
      Modes        "800x600"
   EndSubSection
EndSection

Section "Screen"
   Driver          "SVGA"
   Device          "Primary Card"
   Monitor         "Primary Monitor"
   DefaultColorDepth 8
   BlankTime       0
   SuspendTime     0
   OffTime         0
   SubSection "Display"
      Depth        8
      Modes        "800x600"
   EndSubSection
   SubSection "Display"
      Depth        15
      Modes        "800x600"
   EndSubSection
   SubSection "Display"
      Depth        16
      Modes        "800x600"
   EndSubSection
   SubSection "Display"
      Depth        24
      Modes        "800x600"
   EndSubSection
   SubSection "Display"
      Depth        32
      Modes        "800x600"
   EndSubSection
EndSection

Section "Screen"
   Driver          "VGA16"
   Device          "Primary Card"
   Monitor         "Primary Monitor"
   BlankTime       0
   SuspendTime     0
   OffTime         0
   SubSection "Display"
      Depth        4
      Modes        "800x600"
   EndSubSection
EndSection

Section "Screen"
   Driver          "VGA2"
   Device          "Primary Card"
   Monitor         "Primary Monitor"
   BlankTime       0
   SuspendTime     0
   OffTime         0
   SubSection "Display"
      Depth        1
      Modes        "800x600"
   EndSubSection
EndSection

この情報があなたの探していたものかどうか選択してください。
yes/まさにこれだ!   no/違うなぁ   part/一部見つかった   try/これで試してみる

あなたが探していた情報はどのようなことか、ご自由に記入下さい。特に「まさにこれだ!」と言う場合は記入をお願いします。
例:「複数のマシンからCATV経由でipmasqueradeを利用してWebを参照したい場合の設定について」
Follow-Ups: