2.6: The hardware reports a non fatal, correctable incident occured on CPU 0.

[lkml _at_ xxxxxxxxx]

Hi!

I did have some very scary issues today playing with 2.6. The system was 
booted and ran several times today, the longtest uptime was approximately 
about an hour.

But then shortly after having booted 2.6 I got syslog messages: 

The hardware reports a non fatal, correctable incident occured on CPU 0.

I shut down the machine. After this my Athlon XP 2200+ showed up as 1050MHz in 
BIOS an indeed the bus frequency was set to 100 instead of 133 MHz (how can 
an OS change the BIOS?!) - nevertheless the CPU should have shown up as 
1500MHz. I set it back to 133 MHz - which resulted in the machine did not 
even reach the BIOS no more but was rebooting automatically prior to it. I 
turned off the machine for some seconds - no change. I turned it off for a 
few minutes and the BIOS showed up again - with 1050MHz. So I had to set the 
freq back to 133 MHz a second time. I booted my 2.4.21 kernel which seems to 
run.

What the fuck is going on here?? As far as I figured out this has something to 
do with MCE (CONFIG_X86_MCE=y, CONFIG_X86_MCE_NONFATAL=y) (?).

TIA
Timo

-
To unsubscribe from this list: send the line "unsubscribe linux-kernel" in
the body of a message to majordomo _at_ vger.kernel.org
More majordomo info at  http://vger.kernel.org/majordomo-info.html
Please read the FAQ at  http://www.tux.org/lkml/